View Single Post
  #3 (permalink)  
Old 04-25-2014, 07:13 PM
Sta2lt Sta2lt is offline
Member
 
Join Date: Sep 2011
Location: Oregon USA
Posts: 503
Default Re: Grain matched box

Thanks, I cut the top blank and made a quick tenion type jig from scrap ply and a cut off of the top blank, stood it on edge and ran it through the table saw. The top was then rabbited on the underside so it sits down in the box a 1/2 inch. I was worried about how to secure the top but it ended up being kind of a piston fit.
Reply With Quote