Thread: Lathe Stand
View Single Post
  #9 (permalink)  
Old 12-03-2013, 05:16 PM
MichaelKellough's Avatar
MichaelKellough MichaelKellough is offline
Member
 
Join Date: Jul 2008
Location: The northernmost end of the southernmost county of New York
Posts: 4,525
Default Re: Lathe Stand

Quote:
Originally Posted by Sta2lt View Post
Thanks Randy, It is nice to have someone to bounce questions off.

I have so far purchased a few turning tools from Dave at D-Way tools and I got a CBN 180 grit wheel for my Baldor grinder from him also. I also bought a Wolverine jig at Dave's suggestion.

I hope to be setup and ready to turn some things when the stand is done curing. I need to make a template to drill holes for the bolts to hold down the lathe. The books says the holes are 5/16 x18 but they sure look smaller than that!

Mark
Wise!
Reply With Quote