Thread: Crib project
View Single Post
  #6 (permalink)  
Old 08-29-2012, 12:34 AM
Paul Paul is offline
Join Date: Jan 2011
Posts: 316
Default Re: Crib project

I didn't take many pictures along the way- here are the bending forms and one of the pattern routing jigs made for the project:

The Festool MFS was fantastic for cutting the 16 mortises for the bed rail hardware:

This is a side rail showing one end of the hardware connection:

These are the raised panel assembly ready for glue up - the raised panel itself got a little pre-finish:

Wet sanding with 2000 grit pad on the rotex is starting to produce a good shine on the front and back rails

Sorry - didn't mean to go overboard with the pictures - especially after I said I didn't have very many.
Reply With Quote