View Single Post
  #5 (permalink)  
Old 12-11-2009, 12:56 AM
JimKirkpatrick's Avatar
JimKirkpatrick JimKirkpatrick is offline
Member
 
Join Date: Aug 2008
Location: Central MA
Posts: 488
Default Re: Bridge City Toolworks KM-1 Kerfmaker reviews

Neil, On the table saw setup, I used the same procedure as you did. I can't even imagine doing it with caliper. How can you move it within a thousand of an inch by hand! I got the same results as I did with the router setup. BTW, My digital caliper showed the straight bit to measure dead nuts .5".
I must be all thumbs. So far not impressed.
Reply With Quote