View Single Post
  #7 (permalink)  
Old 10-31-2009, 01:11 AM
MichaelKellough's Avatar
MichaelKellough MichaelKellough is offline
Member
 
Join Date: Jul 2008
Location: The northernmost end of the southernmost county of New York
Posts: 4,525
Default Re: Palm brace and drill driver set from BCTW

Those bits should work at least as well as ordinary 1/4" hex shank bits. If BCT persuaded the manufacturer to tighten up the specs they should work even better, but they still won't be as good as Cetrotec bits. However, at the low low RPMs you're going to get with the hand cranked brace a little runnout won't matter.
Reply With Quote