View Single Post
  #4 (permalink)  
Old 07-16-2009, 09:53 PM
RogerSavatteri RogerSavatteri is offline
Member
 
Join Date: Aug 2008
Location: Los Angeles
Posts: 971
Default Re: Bridge City's KM-1 and the TS55/TS75,,,,,,

Quote:
Originally Posted by Poto View Post
It's possible that the Qwas Dogs would be perfect as stops, though the round edge might make them a little shaky. I'd guess that the KerfMaker could replace my set up blocks that I use in combination with the Qwas Dogs to get repeatable cuts on the MFT...
Peter,,,,

What if you place an aluminum rectangle stock against the Quas Dogs and "Kerfsure" (measure) off of that. I'm thinking of a 1 by two inch aluminum rectangle hollow stock.
I use them all the time for both gluing and using as a straight edge.

these folks carry it.. Industrial Metal Supply Co. - San Diego
See picture below....

,,,,,r

.
Attached Thumbnails
bridge-citys-km-1-ts55-ts75-picture-7.jpg  
Reply With Quote